Linksys Re6300 Reset Process
2 months ago
2 min read

Linksys Re6300 Reset Process

Linksys RE6300 Reset refers to the process of restoring the Linksys RE6300 Wi-Fi range extender to its default factory settings. This erases any custom configurations and settings that may have been set up previously and restores the device to its original state. A reset may be necessary if the extender is not functioning properly or if there are issues with connectivity. 

The Linksys wifi range extender reset process typically involves pressing and holding the reset button on the device for a certain amount of time, which can vary depending on the specific model of the extender. After the reset is complete, the extender can be set up again using the default login credentials and network settings.

Now the question arises how to reset the Linksys RE6300 Extender, Don't worry we will provide you with easy guidelines to do so.

There are some following steps to do the Linksys RE6300 reset procedure:

  • Launch a web browser like mozilla Firefox

  • If your extender is unconfigured yet,use the ethernet cable so that you can connect the extender with your router.

  • Type IP address (192.168.1.1) in the address bar of the web browser.

  • Type your Username and Password in the popped up box.

  • The default  username is admin and password is password respectively.

  • Click on the Reset configuration on the management tab.

  • Click on save reset.

Why should I reset my Linksys RE6300 wireless extender?

Linksys RE6300 reset can be done due to reasons listed below:

  • Experiencing inconsistent router connectivity problem.

  • If you are attempting to install your wifi range Extender before but you are unable to reach Linksys smart wifi setup page.

  • When the light on Extender is uncertain blinking

  • When you again and again try to 

  • Install your range Extender after many failed attempts.

Linksys RE6300 reset using the web browser

We will teach you in an easier way in detail.

Reset through the Linksys smart wifi Setup Page 

  • Open your desired web browser.

  • Type the IP address i.e. 192.168.1.1 or type the web address of linksys.

  • Type the Username and password 

  • Once you are Logged in the settings portal , Move to the administration tab.

  • In the administration tab , click on the factory default and reset the defaults

  • Now disconnect the extender for the power supply and restart it to complete the restore process.

Linksys RE6300 using the Reset  Button

The Linksys RE6300 extender can be reset using the reset button. Locate the reset button on the extender, typically on the bottom or back of the device. Press and hold the button for 10 seconds until the LED light on the extender starts flashing. This indicates that the extender has been reset to its default settings.

Once the reset is complete, you can reconnect to the extender's Wi-Fi network using the default network name and password, which can be found in the extender's user manual. After connecting, you can reconfigure the extender's settings according to your preferences using the web-based setup page or the Linksys app.