It is ideal not to overlook a leaky hot water system if you do not want to find yourself in a significant risk or dangerous situation. If you have observed slow or little hot water, or even worse, no hot water, it is advised to contact professional hot water repairs in Sydney. It is advisable to act as soon as you notice a problem with your hot water system since a little issue may quickly escalate into a major one. We have listed below the steps that you should take when you find a hot water problem.
Detect The Leak
Before you call a hot water plumber in Sydney, you need first to determine the source of the leak. Is it on top or at the bottom of your hot water cylinder? Is it coming from the pressure relief valve (PRV) or the pressure/temperature relief valve (PTRV)?
Things may be less serious if it's the PRV or PTRV. It is usual for these valves to leak a little amount of water occasionally, but not all of the time.
You can locate the valve towards the top or bottom of the tank, then raise the silver lever three or four times to open, close, and remove any obstructions. Your problem is solved if the water flow ceases. If it continues to run, you will most likely require a new valve. This is a low-cost fix that can extend the life of your entire system and save water waste, so it's definitely worth performing.
If you notice the leak coming from the top or bottom of your electric or solar hot water system, switch off the power at the power board. This is a critical step since a straight hookup of power and water can be quite risky. Most of the time the system should have its own fuse or circuit breaker, allowing you to continue using other appliances and lights.
Turn Off Water Supply
Next, switch off the water supply to the heater through the intake line. This is true for electric, solar, and natural gas hot water services.
On a pipe running into the bottom of the device, look for a small black tap or lever valve. Turn the same completely off. Turn off the water at the mains water meter if you can't find the inlet tap or if it has seized up. But first, fill the kettle or a jug with water for drinking and have a couple of buckets of water on standby for flushing the toilet.
Consider Your Alternatives
You now have a hot water system that is either damaged or shut off, and you need to know what you should do next. Some individuals try to fix their hot water system problems on their own, and it occasionally succeeds. However, in most circumstances, a broken hot water system is a symptom of a larger problem, and fast remedies are akin to putting a band-aid on a wound. Your fast fix will eventually unravel, leaving you with a worse problem than you started with.
In such cases, it is best to contact hot water system repairs in Sydney as soon as possible, because keeping it in the same state for even 24 hours may cause more harm.
Make Sure To Hire A Professional
While looking for a professional hot water repairs in Sydney, make sure you select the finest service that will help you have your job done as soon as possible. Before you recruit someone, make sure they meet the following requirements. They should expertise in:
Water heaters that run on electricity
Water heaters that run on gas
Solar water heating systems
Heat exchangers
Solar hot water systems
Instead of duping you and forcing you to pay for unneeded repairs, they should be able to supply you with the greatest solutions and support. They should be able to make things as simple and convenient as feasible. Visit the website to know more.