7 Steps of Wooden Wardrobe Manufacturing: A Discussion

The word "wardrobe" means a standing closet to store clothes. The word appeared in the English language in the early 14th century. Manufacturing a wardrobe is not an easy job but there are some essential steps to be followed. Individuals or professional wardrobe manufacturers generally implement these 7 steps to deliver a perfect wardrobe. In this blog, we will try and understand these steps in depth. So that, the potential users can be helped with an enlightening read.

7 Steps in wardrobe manufacturing

Precise work and good-quality materials are needed to attain the best possible outcome. Carpenters need materials like plywood, timber, rolls of edge bands, drawer slides, drawer slides, and an edge band trimmer. Manufacturers use modern designs so that they can be customized as per choice. The steps are as follows:

Getting started

The first step includes cutting the plywood into manageable sizes using a circular saw and Kreg rip-cut guide. Make sure all the necessary cuts are done before assembling. After cutting them into manageable sizes, take them to the table saw for the creation of drawer spaces. For the middle divider, cut up a dado joint. It saves time in the end in the aligning process. Use screws or pocket hole connection jigs to plug the holes from the top and bottom shelves.

Frame building

First, make sure all the pocket holes are properly covered. Locate the parts for building the frame. Use wood glue to join the parts as it gives added strength.

Adding dividers and back

Spacing is important in building a wardrobe. After arranging the frame concurrently, add the bottom shelf to the drawer compartment. Locate the next shelf with the drawer enclosure, the one with the dado cut. The draw cover needs to fit within the space having the same room around the sides, the top, and the underside. Use the middle divider to fix the space for the top shelf. Use wood glue on the joints and set the divider in its place. Apply glue to the exterior where the plywood backing is going to fit. Add brad nails to hold things in place on top and bottom in addition to adding clamps and weights.

Drawer building

Drawers are made of two parts, plywood sheets and trim to cover up the visible layers. Trim the edges and cut the sheet as per the size. Use glue and clamps to assemble. To assemble the drawer, glue the joints. A band clamp is necessary to keep the shape intact. Double-check the measurements.

Edge banding

Nowadays, to give a finishing look, wardrobe manufacturers use iron-on edge bands. Apply the edge band to all the visible ends. Use a 3/8 dowel to seal the holes from the pocket gaps. This enhances the appearance.

Sand and apply finish

Use sandpaper for the entire wardrobe. Add support for the shelves. Use paint to differentiate the clothing area and drawer front.

Installation

The installation of a modern-day wardrobe is often an unsung story of hardship. Life is fast and is gradually being deprived of space. Therefore, installing a wardrobe is a rather demanding innovation. And this innovation is infused from the very beginning of the manufacturing process from selecting the materials and planning the enhancements. A delivery experience, only the best wardrobe manufacturers can ensure!